Description
Comparison points and tradeoffs
When comparing 7/8′ to 1′ Crank Shaft Adapter Stainless Steel Crank Shaft Sleeve(w/2pcs Key) fit for Gas Engine Pulley Crank Shaft Predator Pulley with other Crankshaft Pulleys options, use this source-backed detail as the primary discriminator: Product identity: 7/8′ to 1′ Crank Shaft Adapter Stainless Steel Crank Shaft Sleeve(w/2pcs Key) fit for Gas Engine Pulley Crank Shaft Predator Pulley.
Use this second fact to evaluate the tradeoff: Works with Engine Crank Shafts to enlarge the crank diameter and increase the shaft size to fit pulleys, gearboxes, etc. A third point to compare across alternatives is: Application note: Works with Engine Crank Shafts to enlarge the crank diameter and increase the shaft size to fit pulleys, gearboxes, etc.
Alternative-selection boundary
Choose an alternative when its stated identifiers, application, package, or specifications better match the requirement; no unverified competitor claim is introduced here.
Complete source-backed product details
- Product Dimensions
:
1 x 1 x 1 inches; 3.53 ounces - Date First Available
:
November 13, 2024 - Manufacturer
:
Swilpool - ASIN
:
B0DMV6R5XF - Country of Origin
:
China
The Sleeve outside diameter is 1.02”;the Sleeve length is about 3” .
Crank Shaft Adapter Pulley kit is made of Stainless Steel 304.
Universal design, fit for most engine.
The crank shaft sleeve is constructed with durable metal and upgraded design which can extend service life of gas engine crank shafts.
Works with Engine Crank Shafts to enlarge the crank diameter and increase the shaft size to fit pulleys, gearboxes, etc. DIY install a Shaft Sleeve Adapter kit will help reduce the necessity of buying a new motor or pulley, to maintain existing components and speed/power requirements.
Olin Christian –
Wasn’t t want it said it was.
Marcelo G. –
Good quality metal sleeve, had to work the key a little to make it fit but it works fine.
C –
As long as you were looking to adapt a 7/8 shaft to a one inch shaft you are in the right place. Depending on the application, you might need to beat it a little bit to get it in, but it will fit.I don’t know who needs to hear this, but you cannot adapt a three quarter inch shaft to a one inch shaft with a 7/8 to 1 inch adapter. I typically use these to adapt a brake kit I like to use. This worked perfectly fine for that.
OLE HACKER –
After installing the sleeve on the shaft it was too big to fit into the blade adapter. Had to machine down the OD of the sleeve at least .025 to get it to fit. Also key was too thick had to machine it down as well. A lot of extra work.