Description
Comparison points and tradeoffs
When comparing MSD 7564-HC Solid State Relay, 35AX4, Red with other Starter options, use this source-backed detail as the primary discriminator: Category: Replacement Parts / Switches & Relays / Relays / Starter.
Use this second fact to evaluate the tradeoff: Four independent channels can be activated using either power or ground. A third point to compare across alternatives is: Combined total continuous current rating of 140 amps.
Alternative-selection boundary
Choose an alternative when its stated identifiers, application, package, or specifications better match the requirement; no unverified competitor claim is introduced here.
Complete source-backed product details
Clean up your wiring with an MSD Solid-State High Current Relay Block. This high current module takes the place of 4 standard relays and eliminates unsightly wiring. Four independent channels can be activated using either power or ground. Each channel is capable of handling up to 35 Amps of continuous current, providing up to 140 Amps of power. It also has the capability of Pulse Width Modulation (PWM). With a PWM input, you can control the output at a rate of 15 hertz and a duty cycle of 50-90%. Controls electric fans, water pumps, nitrous solenoids, auxiliary lighting and any other electrical accessories that would normally require a relay. LED status indicators ensure proper wiring and operation of each channel. Should a problem arise, the relay block has built-in automatic over-temp, short circuit, and overload protection, as well as a channel reset. The solid-state high current relay can easily be mounted using the supplied hardware and mounting tabs that can be rotated 90° to accommodate various mounting locations. It’s compact and clean design will make your wiring project a breeze.
Source product highlights
- Operates from 7-Volts to 20-Volt supply
- 4 Independent Channels, 35 Amps each continuous or 100 Amps for 8 seconds
- Combined total continuous current rating of 140 amps
- Channels can be run in parallel for devices requiring more than 35 Amp single-channel rating
- Multiple mounting options
Jeff Waller –
Could be better.May i suggest some improvements….Instead of having set screws to pressure fit the connections, which will eventually come loose, have a ring terminal post for the connections. Yes, i realize this will change the unit into a larger form factor.