Description
Comparison points and tradeoffs
When comparing Motion Pro 08-0551 Bearing Driver Set with other Tool Kits options, use this source-backed detail as the primary discriminator: Product identity: Motion Pro 08-0551 Bearing Driver Set.
Use this second fact to evaluate the tradeoff: Application note: Fits bearing with 12-25 mm i. A third point to compare across alternatives is: Fits bearing with 12-25 mm i.d. and 32-47 mm o.d.. Adapters can be changed quickly to accommodate a wide range of bearing combinations. Durable steel handle and anodized aluminum drivers. Can be used with a hammer or shop press. Laser etched adapters for easy identification. Comes with protective blow molded case.
Alternative-selection boundary
Choose an alternative when its stated identifiers, application, package, or specifications better match the requirement; no unverified competitor claim is introduced here.
Complete source-backed product details
Fits bearing with 12-25 mm i.d. and 32-47 mm o.d..
Adapters can be changed quickly to accommodate a wide range of bearing combinations.
Durable steel handle and anodized aluminum drivers.
Can be used with a hammer or shop press.
Laser etched adapters for easy identification.
Comes with protective blow molded case.
Source product highlights
About this item
- Fits bearing with 12-25 mm I.D. and 32-47 mm O.D.
scott –
there very small so it,you should really look close at sizes so my bad
Dantrax –
Check your bearing hole and diameter sizes first. There are No included directions. If you look at the picture the screw goes up through one of the five bearing hole sizes and through the correct diameter size cup and into the handle. Then flip it over and put your bearing on top of the bearing holder. I had to screw the 17mm into the 40mm cup to tap the front wheel bearings in. Then I screwed the 20mm into the 47mm cup to tap the rear bearings in. This tool holds the bearings aligned pretty well as you tap them into the wheels. Take your time and check the alignment after every tap as you drive the bearing into the wheel. Worked way better than trying to use the old bearing to drive in the new bearing. No side to side slipping or cocking of the new bearing this way. If you have bearings to install you should give this tool a try.
Customer –
handy tool
Brian ferryman –
Such a good product a little pricey I think but worth every penny very strong and helped me get the bearings out of my cases with ease would recommend to anyone looking for a good driver set
Demonio –
Good quality bearing driver kit from Motion Pro. Flawless purchase thank you.
Steve T –
The tool is simple to assemble and fits a variety of bearings that are common on motorcycles. I had a bearing to replace inside my engine case, and the tool allowed me to quickly install with a mallet. Another bearing needed to be pressed into a housing that could be put on the hydraulic press, and the tool worked perfectly in the press. It is hard to find bearing drivers that are not specifically designed for automotive wheel bearings. This tool was the perfect solution for my project.
Aaron Hansen –
Fast shipping, brand new. Item as described.
Customer –
Title says it all. Don’t cheap out and buy a tool that will damage your bearings. Pricey but worth it imo.
Steve gagne –
Super
Francesco Falsini –
Super good quality!
MikoLee –
I damaged multiple bearings trying to use the old socket method. I decided to just get this set and wow. It was so easy to set my bearings properly. I just wish it wasn’t so expensive, but for me it was worth it.