Push Spring Assembly Set for Pop Up Camper Lift System | Options and Comparison Guide

Push Spring Assembly Set for Pop Up Camper Lift Systems – 146 Inches.
The Push Spring Assembly Set is a set of lift springs designed to fit all pop up camper lift systems. Not all pop-up camper lift springs measure 146-inches, so this set of springs may need to be cut to length depending on the model of camper they will be installed on. The diameter of these push springs measure a 1/2 inch.
You can identify if you have the lift system if your winch is mounted on the tongue of the camper and you have only one cable running underneath to a pulley in the .
This push spring assembly includes two 146-inch push springs and on the following pop up campers:
Camplite / Damon -since 1993-
Dutchmen -1993 – 2003-
-since 1993-
-since 1987-
/ Flagstaff -some models since 1994-
Skamper -since 1977-
Starcraft -1993 – 2008-
Sunlite -1987 – 1994-
Sylvan Sport -since 2008-
Van / -1989 -1990-
-1995-2012, 2018–
Notice From The Manufacturer:
1. Remove the plate by removing the two -tapping screws.
2. Remove the two screws that attach the spring tubes to the tube.
3. Remove two screws each from floor plates that attach spring tubes to the frame of the camper.
4. Pull the spring out from the bottom of the telescoping posts.
5. Pull the spring tube of the spring.
6. Pull the spring assembly -2 springs attached- out of the tube.
7. Put the new spring assembly in the tube and push all the way to the stop. Note: The cable lies the springs and must freely.
8. Put the spring tubes on the springs. -You may need to put some oil in the tube to ease pushing spring through-.
9. Attach the spring tubes to the corner of the frame of the camper.
10. Attach the spring tubes to the tube.
11. Attach the bar.
12. Repeat the above procedure on the opposite end of the camper if necessary.
You will need 2 sets for and replacements. 1 set for the and 1 set for the